How to Apply Weatherwash Exterior Sealer​

Weatherwash Exterior Sealer will not form a coating on top of wood, but rather protects from the inside out. Use WeatherWash Exterior Water Sealer on all raw or WeatherWash stained wood projects that will be outside. This includes fences, decking, shiplap / tongue and groove siding, barns, doors, windows, trim and furniture.  

MATERIALS

  • Weatherwash Exterior Sealer
  •  Brush, Roller, Spray Gun, or Flood System​ 
  • ​​DRENCH WOOD

    1. Prepare & Apply

    Apply Weatherwash Exterior Sealer to bare wood or Weatherwash-stained wood. For best results, apply when temperatures are above 50°F and below 80°F.

    2. Saturate the Wood

    Mix thoroughly. Do not thin. Use a brush, roller, or sprayer to coat all wood surfaces, including edges and end grain. Brush out any puddles while wet.

    Sealer may be applied on-site. Protect surrounding plants and concrete from overspray, as the product can also seal porous concrete.

  • AIR DRY

    3. Allow to Dry

    Allow the sealer to air-dry naturally. High humidity may extend drying time.

    Wood may initially appear darker while wet but will lighten as it dries, preserving the natural appearance of Weatherwash-stained wood.


    4. Apply a Second Coat

    Wait 24 hours before applying the second coat. Repeat Step 2 for thorough, even coverage.

  • REAPPLY

    5. Maintain Protection

    Weatherwash Exterior Sealer provides protection for approximately 2–4 years, or until water stops beading on the surface. Exposure and wear may require earlier maintenance.


    6. Clean & Reapply

    To renew protection, clean the wood thoroughly, allow it to dry, and reapply according to the original instructions.

    Compatible paints or stains may be applied over the sealed surface while the sealer continues protecting the wood. Test compatibility and appearance before finishing.